Before & After Photos

This customer had an outdated piece of water treatment equipment that is not softening and creating water that is staining. 

We installed a new WaterCare Acid Neutralizer and WaterCare CR100 Softener so the homeowner now has an efficient, properly functioning system.

The customer had low pH in the house which was causing copper staining and corrosion. 

The WaterCare Acid Neutralizer and TotalCare CR-100 Softener with Wripli technology will correct the pH problems and stop the staining in the water as well as the corrosion.

An older gas water heater was leaking from the bottom.  We went out and replaced it with a new State Gas water heater with an emergency pan and expansion tank. 

During our recent visit, we arrived at the location and engaged with the homeowner. Our scope of work involved accessing the backyard, specifically under the porch, to address the old pump. The old pump was unplugged, and we carefully removed the existing water lines before installing a new 4.5gpm pump. This included the use of 3/4 inch pex pipe leading into the tank, which was then connected to the existing 1/2 inch copper line feeding the hose bib. After installation, we plugged in the new pump and conducted thorough testing to ensure everything was functioning correctly. To assist with winterization, we added new pipe insulation around the pipes and ensured the work area was cleaned adequately. We appreciate your trust in our services and are committed to providing you with the highest quality of service.

Installed new state 50 gallon natural gas power vent water heater with new shut off valve, expansion tank, and drain pan. Piped drain pan in cpvc to sump pump. Filled water heater up and tested all work. Cleaned work area.